This KIT includes the Internal Throttle and Metal Throttle Sleeve that will allow you to use Rubber Grips!
Does NOT come with grips.
• The unique Needle and Ball Bearing Construction creates an extremely smooth operation over competitors internal throttles.
• Throttle also features a spring-assisted return for added safety.
• This kit uses three types of throttle bearings:
5/32" x 5/16" x 1/8"
3/8" x 7/8" x 9/32"
5/8" x 13/16" x 5/8"
• Comes with detailed installation instructions.
• Basic Hand Tools required for proper installation. (No Welding Required)
• The throttle side of the cable goes into a barrel in the throttle and is then secured with the provided set-screw.
• Custom Application for any bike with 1" Handlebars.
• The internal portion of the throttle slides into the handlebars just short of 2-1/2" (Roughly 2-15/16")
INSTALL NOTE: You will most likely need a longer cable to use with this internal throttle kit.
• CNC machined from 6061 Aluminum.
• The throttle sleeve surface is knurled to properly secure your grips.
• The sleeve also comes with stainless steel set-screws to secure the sleeve to your internal throttle.
• Simply slide the sleeve over the throttle, tighten the set-screws and install your favorite set of rubber grips and you're good to go!
Choose from our wide variety of grips or use your own with this kit!
Length (Overall) - 7-1/4”
Length (Internal Portion) - 2-15/32"
Length (External Portion) - 4-3/4"
OD (Internal Portion) - .792”
OD (External Portion) - .998”
Length - 4-5/8”
OD - 1-1/8”
ID - 1.015”
Custom Application for any bike with 1" Handlebars.
Basic Hand Tools required for proper installation. (No Welding Required)